Har installerat ett drag på Previan. Köpte draget från GDW, tror de görs i Belgium. Det var den bästa konstruktionen jag hittade. Beställde från rameder.se och det fungerade bra. (nej jag har inte fått något för att skriva detta)
Jag har gjort några videos där jag går igenom installationen, som var svårare än jag trodde pga av fastrostade bultar. Eftersom de flesta besökare än så länge är från amerika ges en engelsk text nedan.
----------------- IN ENGLISH ---------------
This post is about mounting a Trailer Hitch on a Toyota Previa from 1998.
The Brand of towbar I choosed: G.D.W made in Belgium
GDW = I'm pleased with the quality, it was in my opinion the smartest construction.
I've made a 2 part video showing the removal of bumper and the installation process... and all the problems along the way. Hope you find it of interest. :-)
Towing capacity for this tow bar: 1600 kg which is also maximum cargo for hitch installed in Toyota Previa..
Max vertical load on hitch: 75 kg.
First removing the rear bumper, plenty of rust dissolver fluid used around the bolts and nuts.
The ends of the hitch is attached to the car frame with carriage bolts and blocks of steel with round holes. ... Bumber goes outside the hitch.
No mods were necessary except drilling one hole on the buffer metal frame that the plastic bumper sits on.
Biggest problem was rusty bolts, some were very hard stuck and I pulled some apart (read broke them)
Clean rusty parts, screwdriver and a wire brush.
Rust protection used: boiled linseed oil
Installing a Trailer Hitch, a towbar on a minivan, part 2
Inga kommentarer:
Skicka en kommentar